TronXY/CR10/E10 mount w/autolevel

thingiverse

A remake of a few months on here. But this ended up being the best configuration for my machine. Combines a mix of CR10, E10 and X3a features. I'll tag all the originals once I find them again. This was mixed for my custom machine that started life as a TronXY X3a. Uses the stock aluminum fin/mount assembly. A 26mm all metal throat with heat break mated to an E3d heat block. SS e3dV6 nozzles. 40w cartridge. M3 screw-in thermistor (epcos 100k). 30amp MKS mosfet to the hot end. A Digital_sqrt 900w heater board to the bed.(310x310) mega/ramps 1.4 conversion. DRV2885s all around @1/32 micro step. Use some washers to attach to X Mount. You might have to move up or down a few threads on the throat. Really depends on what your hot end setup is..........Printed in PLA and still going strong after a month. Thought it would warp but it does a good job of isolating the hot end away from the fan. Original Tronxy design was garbage as we all know. It's a tight fit so you might hit it with some sanding if needed. Used the Anet E10 improved fan nozzle and it works great!