Trojan AEV 1/35 Scale

thingiverse

The OP made a great looking vehicle to start with. I rescaled everything to 1/35 and chopped the body and tracks up into multiple parts. I scratch build the hoist. The hydraulic sleeves and the mine arms have holes in the sides, these are for you to use small guage black wire in to replicated hydraulic hoses. The hoist should be workacle, able to rotate left and right and go up and down with the arms and the scoop. The scoop jaws should also be able to open and close. Includes in the files are optionsl side skirts.On the pins holding the arms and hydraulics in place,if you are using a resin printer they should work fine. A filament printer they may not print smooth enough to work. In that case you can use metal or acylic tubing for the proper hole diameters.Revision 1: Split the lower rear hull into 2 parts to make each print a little faster as I have an aversion to 20 hour prints.Revision 2: Change up the left and right mine plow design a bit.Revision 3: Did a correction for the front out track assemblies. And noticed I completely forgot to upload the right side, so fixed that.Revision 4: Made the drivers hatch larger. When I printed it out, it was way too smallRevision 5: Not a revision per se, I hadn't uploaded the right tracks, so correcting that.Revision 6: Made the fascine pipes thicker. The walls were too thin and very difficult to print before.Revision 7: Finally got around to uploading the side skirts.Revision 8: Thickened the side engine vents and support brace for the scoop.