Tripplite 20A server power strip wall clips-V2

prusaprinters

<p>V2 Updated to simplify and strengthen the design similar to the remix posted. Print with the "legs" on plate.</p> <p>I had an old Tripp-lite 6 foot tall, 20A 24 port NEMA 5-15 server power strip designed for vertical installation in server cabinets that I wanted to use for my work bench area to provide a LOT of power outlets for projects. Since I had a 120V - 20A circuit in that area, it was a good excuse to finally use it. However, vertical orientation is less than useful in a garage.</p> <p>I decided to quickly build a set of wall clips that I can screw to the wall and then clip in the power strip to provide an abundance of electrical ports within easy reach. For a 6' power strip, I would recommend to print at least 4 clips and screw them in to studs along the length. I used standard 6 x 1-5/8 gold wood screws I had laying around.</p> <p>Once the clips are mounted, just snap in the power strip with the edge clipping over the front.</p> <h3>Print instructions</h3><h3>Category: Office Summary</h3> <p>V2 Updated to simplify and strengthen the design similar to the remix posted. Print with the "legs" on plate.</p> <p>I had an old Tripp-lite 6 foot tall, 20A 24 port NEMA 5-15 server power strip designed for vertical installation in server cabinets that I wanted to use for my work bench area to provide a LOT of power outlets for projects. Since I had a 120V - 20A circuit in that area, it was a good excuse to finally use it. However, vertical orientation is less than useful in a garage.</p> <p>I decided to quickly build a set of wall clips that I can screw to the wall and then clip in the power strip to provide an abundance of electrical ports within easy reach. For a 6' power strip, I would recommend to print at least 4 clips and screw them in to studs along the length. I used standard 6 x 1-5/8 gold wood screws I had laying around.</p> <p>Once the clips are mounted, just snap in the power strip with the edge clipping over the front.</p> <h3> Print Settings</h3> <p><strong>Printer Brand:</strong></p> <p>FlashForge</p> <p><p class="detail-setting printer"><strong>Printer: </strong> <div><p>Creator Pro</p>&lt;/div&gt;<strong>Rafts:</strong></div></p> <p>No</p> <p><p class="detail-setting supports"><strong>Supports: </strong> <div><p>Yes</p>&lt;/div&gt;<strong>Resolution:</strong></div></p> <p>.2mm</p> <p><p class="detail-setting infill"><strong>Infill: </strong> <div><p>30%</p>&lt;/div&gt;</div></p></p></p></p>