Tripod Snowshoe - 8mm

myminifactory

Snowshoes for a tripod with an 8mm tube can be designed. Scaling up or down might allow the design to work with other sizes. This design is intended for dense snow and a lightweight setup - too much weight will cause them to detach. Limited testing has shown that this design works fairly well in snowy conditions, but it's not perfect. When strapped to a backpack, the snowshoes tend to catch on straps, twisting them around and potentially causing them to pull off. To address these issues, I'm planning a redesign. Instructions: 1. Rotate 30 degrees before printing - this will make the wings horizontal. 2. This design may not work in PLA; it needs flexibility to attach properly.