Tripod Feet for Insta360 Selfie Stick (or legs for most monopods)

thingiverse

This is feet (legs) for the Insta360 invisible selfie sticks, remixed from Mini Tripod 150mm by DiAleksi. With this, you can give your invisible selfie stick (monopod) feet so that it can stand the Insta360 camera upright. I use this for doing virtual tours and Matterport 3D tours. The main changes from the original design in this remix is that it has a printable screw to mount it to the selfie stick, eliminating the need to buy a metal 1/4 screw. The main connector now features a screw thread instead of just a hole, and I made a shorter version of the feet so you can stand your monopod upright on a staircase for doing those Matterport tours. **Required Extra Parts** Three M3 screws are needed, 14 or 16mm length. **Printing Instructions** Print the connector with at least four perimeters and at least twenty percent infill. It must be printed at a layer height of no more than 0.20mm (preferably 0.10mm) to ensure proper screw thread alignment. Print the screw with one hundred perimeters to achieve complete solidity, also at a layer height of no more than 0.20mm. I recommend applying a small brim unless you have excellent bed adhesion. Print three of the feet (either standard or short) with at least four perimeters and twenty percent infill. Layer height is not crucial, as I printed at 0.30mm for faster printing. **Assembly Instructions** Ensure the screw is cleaned thoroughly with a razor to remove any brim or elephant foot. Apply superglue to the threads and screw it into the connector from the top until flush with the bottom of the connector. Allow several hours for it to dry. Install the three feet onto the connector using M3 screws. If you prefer longer screws, you can add a nut on each end but I find it unnecessary. You can now securely attach the whole assembly to the bottom of the selfie stick.