Tripod Extended GoPro Mount

prusaprinters

I needed a way to use the full size tripod I had to hang the GoPro near the print without the vibrations of the file cabinet affecting the film. Took me four prints to get a viable test piece, but that was not the designs fault, more my inexperience with printing. Fourth print worked with a different slicer, because I needed to print it at an angle to fit my bed. Shrunk the Gopro mount side 1mm and the fifth print is about perfect. Feel free to change what you need. Instructions Used Design Spark Mechanical for the design. Printer, QU-BD TwoUp, no heated bed .1275 layer height 40% infill 1.2mm perimeters Support only because of the angle I needed to fit the bed. Repetier Host with Cura Slicer engine. Category: Camera