Tripod Cellphone Mount

thingiverse

I modified my Microscope Phone Holder for tripod use. You can just print PhoneClamp2.stl and PhoneClampHybrid.stl to hold a phone on a tripod in horizontal orientation, or print PhoneClampVerticalTripod.stl if you need the phone in vertical mode. Warning: After scratching the side of my phone on the nut on PhoneClampHybrid.stl, I strongly advise adding duct tape or a rubber band over that part to prevent damage and improve grip. Print Settings Printer Brand MakerBot Printer MakerBot Replicator 2 Rafts Yes Supports No Resolution 0.3mm Infill Default Notes: I printed this with orange PLA at 235 C on a MakerBot Replicator 2, 10% infill, 0.3mm resolution, with rafts on. Other settings are default. Orient the parts as shown in the picture. Post-Printing Parts needed 1x M3 Nut 2x M3x30 (or longer) Screw 1x M3x18 Screw (Alternatively, use M3x20 + extra M3 nut as a spacer)