Triple Feed Patch spacer and assembler stand

thingiverse

Here's my method to assemble Maarten Baert's Triple Feed Patch antenna. 1. Thread 10-12mm wires of 1mm into holes of assembler until bottom is reached. 2. Place big pcb on top, solder in place and trim excess wire length. 3. Remove assembler and you'll have 7-8mm wires remaining for next step. 4. Use fine sandpaper to carefully sand spacer down to exact 4mm width required. 5. Place spacer and small pcb together, press them firmly into position. 6. Solder wires to small pcb and trim excess wire length. 7. Complete assembly steps and you're done!