Trim Ring & Cap for P6*6 Pinhole Camera

thingiverse

To improve the appearance and functionality of the P66 3D printed pinhole camera's front face extension, I designed a face plate for its "Shutter Clamp." The plate is specifically made not to vignette the projected film image and should be glued securely in place. The outside perimeter may need slight sanding or acetone smoothing for proper fit. The cap protects the film from accidental exposure, an improvement over previous gaffer's tape use. Please note that this design is licensed under a Creative Commons - Attribution - Non-Commercial license, excluding related content such as photographs and verbiage. Successful printing was achieved using 2 perimeters, 50% infill at 0.25mm layer height and 0.40mm nozzle with Tinkercad and OpenSCAD involved in the creation process.