Tri Spinner Remix Single 608zz Bearing

thingiverse

I'm a compulsive fidgeter. I couldn't resist trying out the spinner without extra bearings on the end. It spins smoothly, just as expected. With only four 608zzs available, I had to make multiple versions. I knew it was a matter of time before my kids would want one for themselves. To add some weight and stability, print with higher infill settings than usual. A tip: sanding the top surface of the cap can greatly improve grip for your fingers. For an extra boost in spinning performance, give your bearings a good spray of WD-40. This spinner was printed using Maker Geeks' Maker Series PLA at 230c. It was designed and remixed in 123D Design. The print settings were as follows: layer height set to .4mm, shells at 3, and infill ranging from 60 to 80%.