TREE OF LIFE

thingiverse

I'm showcasing a miniature masterpiece called "The Tree of Life." Initially, I designed it at the start of this competition and was hesitant to share it, but after some deliberation and two printing attempts, I've finally perfected my work. "The Tree of Life" measures 12 cm by 11 cm in size, with a depth of 4.6 mm. It took approximately 3 hours and 44 minutes to print. I utilized a combination of filament colors: "Black Alumina," "Coffee," and "White" to bring this artwork to life. Here are the key parameters I used for 3D printing: * Fill rate: 50% * Print speed increased by 50% for enhanced rendering * PLA printing temperature set at 215 degrees Celsius * Plateau temperature maintained at 60 degrees Celsius * Layer thickness set at 0.2 mm * Hull thickness set at 1.2 mm (both above and below) * Printing was done without support.