Treasure Chest with Hasp and dummy padlock - for Glowforge

thingiverse

This is essentially rmm5t's Treasure Chest, scaled down for 1/8-inch plywood. The layout is designed to be cut from a single sheet of 12 x 20 x 1/8-inch (Proofgrade) material. When removing the pieces from the laser cutter, note the orientation of each part. This design takes advantage of continuous grain patterns to ensure optimal stability. This treasure chest can be assembled without glue, but it will be extremely fragile in that state. Using glue will result in a solid and usable piece. I recommend using a gel superglue specifically formulated for wood if you can obtain it. The hinge holes are sized to accommodate a wooden BBQ skewer, so you may need to make adjustments as needed. The "padlock" is held together with four Chicago screws, 5mm in diameter and 8mm deep.