Traxxas Xmaxx 8s Drive Cup Tensioner (READ ALL INSTRUCTIONS!!!)

thingiverse

Misc Notes VERY IMPORTANT: Do NOT rescale when slicing! The part should fit snug onto the drive cup! Also, MAKE ABSOLUTE SURE you do 100% infill. Remove drive cup Remove axle from drive cup Lay tensioner flat on a extremely hard surface that does NOT absorb shock, like concrete Put the part of the drive cup that the axle slides into on top of the tensioner Using a hammer, tap the part of the drive cup that mounts to the differential until the drive cup goes into the tensioner about halfway Flip the entire drive cup that should now have the tensioner half-mounted to it so that the tensioner is facing up Using the hammer, tap the tensioner so that the top of the tensioner is snug on the edge of the cup Remount the drive cup to the car, and be absolutely SURE that the screw is in and is tight Wiggle or slide the axle back into the drive cup. Try not to let the tensioner move. If it does, just use the back of the hammer to get it back at the edge of the drive cup