Traxxas TRX-4 Wall mount

prusaprinters

<p>Wall mount for the Traxxas TRX-4 and other similar RC trucks/cars</p> <p>It hooks around the rear axle of the vehicle and screws to the wall with two #10 wood screws (canada, not sure if there is a metric equivalent - 0.193"/4.9mm diameter thread). You should NOT use countersunk screws, they will probably split the plastic when you tighten them.</p> <p>I tried to include the actual original parametric model so it could be tweaked to fit any other RC too but Solidworks file formats are not allowed on Prusa Printers. The Step file should include the geometry needed to tweak it for your specific measurements but the honeycomb/hexagonal pattern will probably not come out too great.</p> <p>It you have a specific center distance between the hooks you would like or a custom length of hook let me know what vehicle its for and I can re-upload it with the cool pattern on it.</p> <p>I would suggest using PETG for this, my original was PLA and over time the bolts have half pulled through. The PETG hasn't had any issues yet. My TRX is REALLY heavy and it's been good.</p> <h3>Print instructions</h3><p>I have used 0.3 and 0.2mm, both have been fine. Slightly higher temps than normal are good for the strength and layer adhesion. Its a pretty forgiving print in general to be honest.</p>