Traxxas Slash 4x4 stand for overhead work

cults3d

With these two holders, you can turn the car on its back without bending the body teher :-) 50% Infill, 2 outer contours, 2 bottom layers, 4 top layers. You will also need 2 countersunk screws M3x10 Press with a little force on the damper bridges, goes a little hard at first, but that gives itself after a few tries :-) Place parts on the printer with the lettering facing down. Have fun with this simple little tool :-) With these two brackets you can turn the car on its back without bending the body-stakes :-) 50% infill, 2 outer contours, 3 bottom layers, 3 top layers. Pressing to the shock towers with a little force is a bit difficult at first, but that will work out after a few tries :-) Place the parts face down on the printer. Have fun with this small, simple tool :-)