Traxxas Rear Wing for Rustler/Bandit/Slash (All 1/10, 2WD)

thingiverse

Also check out my front wing - this will help even more with speed runs and keep the car planted firmly to the ground at high speeds. It works exceptionally well with this wing. https://www.thingiverse.com/thing:2563275 Now allows for a Traxxas wheelie bar to be installed using some M3 screws. I used M3x40 screws to attach the wheelie bar securely to the rear. The wing mounts attach firmly to the rear where the stock bumper normally goes, and the wing slides snugly onto the attachment rails on top of the mounts. This allows the car to generate plenty of downforce and maintain great control at high speeds. I've run this with my Rustler VXL at 70+ mph and it performs wonderfully. Printing Recommendations: WING: Print upright with the back of the wing facing upwards, attached firmly to the buildplate. Print with supports on the build plate. MOUNTS: Print with supports on the build plate, with the mounts laid flat on the thin side of themselves. Print with PLA, ABS, or Nylon. Performs best with Nylon, although it may be challenging to print.