Traxxas 4tec 2.0 Chassis Spoiler Mount

thingiverse

Had to brace the wing legs with two pieces of glue stick and tape to strengthen them during printing. Made this 1/10 Traxxas 4tec 2.0 chassis mustang bodied car. It is a modular design that allows for different style of wings and tips. With that being said I have a few designs I am making for the ends and the wing itself. It mounts almost 100% flush in factory location with 3 screws along with the small chassis enforcement bar. It does flex very well and can hold the weight of the car well, although I cannot promise the spoiler / wing legs will hold the full weight in a straight up and down because of the print position. The wing / spoiler is held on by one screw in each leg, the holes are 3mm x 0.50 thread pitch and 10mm deep in the design, hard to tell if the threads are actually there but should be perfect for all RC screws up-to 10mm in length. Print Settings: PLA PRO -Inland Extrude Temp - 219c First Layer Hight - .32 All other layers - .20 Infill - 25% Concentric Top / Bottom Layers 85% speed on Prusa mks3