Travel Crib/Cribbage Board & Pegs

thingiverse

Note 1: Thingiverse has displayed the STL of the board upside-down towards the viewer, but it prints exactly as shown in the photo. Note 2: Print the board at an infill setting between 15% and 25%, or use whatever setting you prefer, but make sure to use a 100% infill for the plug and pegs. This crib board features a storage hole with a screw plug that allows four pegs to be stored inside for traveling. To prevent the pegs from jamming in the hole, ensure they are all inserted with their heads pointing in the same direction. To reduce the risk of the print head melting the thin shafts of the pegs, it's recommended to print at least four pegs together in one go. Using cooling features can also help with this process. When printing the pegs, place them with the sphere side facing down. This approach yielded better results than printing the pegs with the sphere side up. The plug fits snugly into the hole and screws up flush to the board. The slot was designed to accommodate a small coin.