Travel Catan

thingiverse

This travel-sized Catan board is fully functional without cards, dice, and build cost cards. It was designed with printing in mind using an MMU, but most parts can be printed independently. For the pieces that currently require MMU (harbor keys, number tokens, trophies, and robber), you may be able to load the accents as sub-parts, adjust their position, and then add filament changes in your slicer. A different box might be necessary for the non-MMU version since some parts are slightly taller and won't fit in the current box. If you print non-MMU versions, please let me know the height of your stacks so I can modify the current box accordingly. To print multicolor pieces, load the main part and additional parts, change the type of the additional parts to "modifier," and select the desired filament. Box lids and robber should be printed face down, while harbor keys and trophies are best printed face down as well. You will need to print: 1. Box bottom 2. Box top plain (add box top Catan outline and fill as modifiers for MMU) (non-MMU see note below) 3. Card box 4. Card box lid (add card box lid color accents as modifiers for MMU) 5. Six Standard Board Sections 6. One Desert Tile 7. Nine Plain Water Tiles 8. Nine Harbor Tiles 9. Eighteen Basic Resource Tiles, colored to represent the five resources: four Wheat, four Wool, four Lumber, three Brick, and three Ore 10. Four harbor key blanks with a 3-to-1 harbor key modifier 11. Five harbor key blanks with a 2-to-1 harbor key and resource indicator modifiers 12. One set of number tokens (white with red and black modifiers) 13. One Trophy blank with Longest Road modifier 14. One Trophy blank with Largest Army modifier 15. One Robber blank with Robber Accent modifier (non-MMU print robber blank without modifier) For each player color, you will need: 1. Five settlements 2. Four cities 3. Fifteen roads (face down) 4. One piece box 5. One piece box lid (face down) Note: For non-MMU prints, try adding the Box Top Catan Outline as a modifier to the Box Top Plain and specify in the settings for the outline: no infill, no perimeters, no bottom layer, and one top layer. There is also a customizer called "Name Maker" that allows you to personalize the box lid. The resulting STL should be properly positioned to use as a modifier for the lid. For hinges, use paper clips or 20-gauge wire.