Trapezoid Block

grabcad

Trapezoid Block 1step1: configure material to cast stainless steelstep2:sketch from the side to the specified dimensions step3: use boss extrude to make the geometry the correct distance step4:now from the side without angled cuts sketch out and dimension, the cut extrude step5: from the top of the surface cut a whole through the center of the geometry ---------------------------------------------------Trapezoid Block 2 step 1: from the same surface you sketched on create another sketch and draw a circle in the center of the circle you created, set the radius to the specified radius step2: extrude cut the circle 10mm step3: repeat steps 3 and 4 on the under side of the geometry step4: in the corner of the top sketch out a square and cut extrude ---------------------------------------------------Trapezoid Block 3 step1: using the convert entities tool on the top of the surface you can make the extrusion by clicking offset entities and setting that distance to the ones shown in the blue prints ( reverse to sketch entities)step2: use boss extrude on the sketch you just created and set its extrusion to 10mm step3: on the top of the geometry sketch a circle and turn it into a construction linestep4: draw an "X" through the center of the circle with construction lines step5: use the center point straight slot tool and position on the intersection points of the circle and lines created by the X you previously drew step6: dimension all the slots to the specified dimensions step7: use cut extrude and set distance to 10mm