Trapezoid Block

grabcad

Steps:Part 1*-First i made a square sketch- I then used the extrude tool with the drat selection on to slope all the sides-i did the same on top in the opposite direction-I then extrude cut a hole in the center in itPart 2*-First i fillited all of the sides connecting the 2 extrudes together-I then cut 2 circular holes (one on top one on the bottom) bigger than the first cut- I finally cut out a square shaped hole on one of the cornersStep 3*- I added a border around the top using the extrude tool -Finally i added 4 (1 in each corner) straight slot cuts To the corners of the top