Transformers Legacy Tarantulas Spider Legs

thingiverse

With a combination of somewhat loose joints and an open box, there's a good chance you'll lose some of Legacy Tarantulas' legs, perhaps before he even leaves the store! I know I did. With factory replacement parts and exchanges not an option, I turned to 3D Builder and knocked out a couple of reasonably close reproductions! The pieces pictured are rough prints in need of finish work, but presented with the stock parts (I was only missing one) for comparison. The "Fore Leg" parts are for the front/top four legs, the "Rear Leg" parts are for the bottom/back ones. The picture of Tarantulas has a more polished up piece plugged in where his missing leg was. Can YOU tell the difference? Mine do have one significant difference from the stock piece: no gaps in the model. Also, I made the ball joint a tiny bit larger than stock so that it stays in tight. Perhaps TOO tight? Sanding may be required depending on your print.