Trailer for the FPV-Rover

myminifactory

This is a unique adaptation of the OpenRC Truggy designed by Steamerzone. http://www.thingiverse.com/thing:378042 The tires are a remake of the small tire by Bastien. http://www.thingiverse.com/thing:626863 It is created for the FPV-Rover (V1.0) http://www.thingiverse.com/thing:1240754 And for the FPV-Rover (V2.0) https://www.thingiverse.com/thing:2952852 Instructions: Print everything with 15%-25% infill. Support is not necessary. Use PET, Flexifil, Ninjaflex... for the tires. Due to the limitation of my printbed I had to break some pieces into more parts. If your printbed is big enough, print the complete parts (like, frame front, frame rear, fender, ramp, front). Parts to print 1x fender 1x front 1x center 1x frame hitch 1x frame front 1x frame rear 1x hinge 2x side 4x tire 4x rim Parts you need: 2x M5 threaded bar (23cm-24cm) 8x M5 nuts (for each wheel two to center the wheel on the threaded bar) 1x 6mm metal pipe with 5mm hole 1x M3 threaded bar (7cm-8cm) 1x M3 nut 2x M3 washer 1x spring from a pen M3 16mm screws M3 10mm screws