TPU Water bottle handles

prusaprinters

<p>I recently got a water bottle from my work, and decided it needed a handle to make it easier to carry around.</p><p>Then I added two more designs, just in case anyone else wanted to make some for themselves.</p><ul><li>One has a teardrop shaped loop and is easier to grab.</li><li>One has a long loop, also easy to grab but smaller than the teardrop in width.</li><li>One has a small slit where you can loop a lanyard to similar through.</li></ul><p>If they are too tight or loose for your bottle, they should be fine by just scaling them up or down.</p><p>I recommend 2 perimiters and 4 top/bottom layers, 15% infill.</p><p>You can increase perimiters to make it more stiff, and adjust infill to make it softer (though only if there is enough space for infill after perimiters)</p>