TPU - Solar Heater Rubber Washer/Gasket for hose connector

thingiverse

This rubber washer fits specifically on a particular type of solar heater (take a look at the picture of the solar heater... there are many brand names, but if it resembles the pic, then this should work perfectly... If not please leave a comment). These heaters (or replacement parts) often come shipped without the washer/gaskets so now you can easily print your own. Note: These washers fit snugly as they need to withstand water pressure. You will require a significant amount of force, so be extremely cautious not to damage your solar heater, hose or fitting. And of course: use at your own risk! Print them with 100% infill (they only consume a small amount of filament even at 100%) and also use approximately a 1.2mm shell, as well as 1.2mm top and bottom (this leaves very little room for the 100% infill, but doing so alters the printing pattern). I strongly suggest using a brim, but that is entirely optional. Note: This print is intended solely for personal use only, do NOT attempt to print these and sell them without my explicit permission!