TP4056 based charger for 14500 LiIon cells

myminifactory

I needed a charger that fits the protected version of my TP4056 battery for my 14500 flashlights because I already had those lying around. So, I grabbed an AA charger holder from enif and designed a holder for the charger board in Fusion360, then combined both STLs in Windows 3D Builder and sent them off to print. Problems with this WIP version: The holder is a bit too loose with 14500 cells, so I'll need to configure a custom one from the adjustable source. Also, the little springy tabs to latch onto the charger board are way too small and the part extending over the PCB failed to print altogether. It's a tight enough friction fit for me, but I consider that unreliable. So if there is enough interest or I need more of these, I'll fix them and upload V2.