ToyWorld Constructor Devastator Gorilla Arms Fix

thingiverse

With Toyworld Constructor being one of my favorite figures to date I have wanted to get the one thing that bugs me the most about him fixed. His extra long gorilla arms that just hang too low for my tastes. I made some added pieces that work extremely well at raising up his arms approx 1 3/8" (33mm) making him more in proportion with other combiners such as Zeta Superion. I does raise his shoulders up as well of course but when posed it doesn't look off or too high to me. The long arms were much more noticeable in my opinion. The install process is very easy by just removing a few screws in each arm socket and installing the new pieces and screwing them back together. From there the original sockets go into those so you still maintain all the original movement and rotation. Some small screws and a bit of wire are needed to make these stay in the figure but are only added to the 3D printed pieces to give support. My Constructor is a V2 but they seem to all have the same arm joints as the mould has not changed. I also added a peg to mount the large gun on his arm and a simple version of the gorilla arm mod that I was unhappy with as you have to leave the flaps open to use it. NOTE: These pieces will only work while Constructor is in combined mode and would have to be removed if you wanted to display the bots in atl or robot mode. The 3D printed parts go into the spot where the arm joint folds down to be hidden when not combined.