Toyota Tacoma Side Step Bolt Hole Plugs

thingiverse

Print out 12 pieces of TPU from your preferred source, then remove one side of side-steps from a Toyota Tacoma, ideally a 2020 model but likely applicable to those as far back as 2012. Next, use a mallet to knock the TPU pieces into the empty M8 bolt holes after first removing them. The specific hole you're targeting is an M8 bolt hole, so these custom-made plugs should work for any scenario where an M8 bolt was used in your project or repair. To seal the area completely, apply a small amount of silicone to the flat face that will make contact with the body and then use a cotton swap to wipe away excess. This ensures a tight seal when you knock them into place with your mallet.