Toyota Tacoma 2nd Gen Head Unit Trim Clip

thingiverse

To get the Tacoma head unit bezel to work, I had to make some adjustments to the clip's length and shape. The initial Gray PLA prototypes were too short, which caused them to break or pop off into the dashboard. After installing the radio, I found an original yellow clip under the cup holders that used the same design. I then printed a longer version of the clip in ABS for more flexibility. Here are my print settings: Printer: Folger Tech Kossel 2020 Rafts: Yes Supports: Yes Resolution: 0.2 Notes: I needed support for the middle barb to prevent blobs and ensure a snug fit into the bezel tab. I edited this design in Meshmixer, where you can find the mixed file attached.