Toyota Rav4 Samsung S7 Magnetic Charging Port

prusaprinters

<p>My friend had a magnetic wired charger set up in her car but wanted a place to just drop the phone and go.</p> <p>I set this up (by request) to "lock" the phone in behind the shifter, so when you're in drive you cannot access the phone to prevent texting while driving.</p> <p>Note this uses the older style magnetic chargers and would need a small modification to work with more current adapters. If there is interest I might make a modern one or a QI-based one.</p> <h3>Print Settings</h3> <p><strong>Rafts:</strong></p> <p>No</p> <p class="detail-setting supports"><strong>Supports: </strong> <div><p>No</p></div> <p><strong>Resolution:</strong></p> <p>0.2</p> <p><strong>Filament:</strong></p> any ASA/ABS maybe PET <p>Grey/Tan/Match Car</p> <p><br/> <p class="detail-setting notes"><strong>Notes: </strong></p> </p><div><p>I printed these in PLA to test the fit and they work fine... but after a good windows-up heat wave it'll warp too much to get the phone in.</p> You can get power from the nearby cigarette lighter, and just transfer the mirror switch unit over. <p>Since I don't expect anyone to actually use this, I'm leaving all the text and garbage on there. :-P</p> <h3>Post-Printing</h3> <p>Break away the supports in the middle and push your cord in from the back. I like to wrap the cord around in a knot but you don't need to.</p> <p>The part should push right into the car.</p> </div></p> Category: Mobile Phone