Toyota mr2 ashtray iphone 11 pro mount holder

thingiverse

I printed using supports, flipped the model 180* from the orientation it opens in Cura. I would print either with high infill % throughout the whole model, or use blockers and have a higher percent on the actual phone holder part. I had one that was 10% and it got too hot in the car and got deformed. It was designed to hold an iPhone 11 Pro with a thin case, the measurements used for the holder are 148.5mm long/tall, 75mm wide, and 11mm deep. Not sure what other phones will fit. This requires removal of the ash tray obviously.