Toy Car Bridge

prusaprinters

The bridge is sized for HotWheels-style cars.  It is a full-width print on a Prusa i3 MK2/3[S][+].  When its done you'll end up with three components: the center span and the two approaches.  See the gcode notes for the quantities needed for each printed part.The yellow lane marker is achieved with a color change.  The only parts with support are the road deck for the approaches.  It is slightly annoying to remove.  You may get acceptable results without support, but I didn't try.  If you do, please let me know in the comments!The assembly instructions are the same for the center span and the sides. You just need super glue, a couple spring clamps, and a weightLay one of the side pieces on its side on a flat surface (blue parts in the pictureGlue the middle piece (orange in the picture) in placePlace a weight over this and wait for it to dryGlue the other side piece (blue) in placeGlue the road deck in place and secure with a spring clampAgain use a weight to hold the assembly down Assembly isn't hard, but I also didn't optimize the design for super quick assembly.  Please post any questions or suggestions!