Townsfolk Tussle Pond Terrain

cults3d

Instructions: Three files are included for assembly as shown in the image above. The dock is printed upside down to minimize any support needs. On one side of the doc are two short and two longer wood pieces. Those are for the dock posts. I used a hand drill for holes to glue in the posts. Once dry the dock easily glues right on top of em. The other three pieces of wood that are bundled together, are for steps in front of the dock. If you are printing with PLA instead of resin, there will be a lot of noticeable layer lines. This can be reduced in a couple ways. First you can turn on “Ironing” in your slicer. Then after printing you can smooth out the layer lines with a Dremel grinder bit and/or sandpaper. I use both. First the grinder in light small circles. Then I finish with 180 or 220 sandpaper. Optional: The bushes are sized for placement at the opposite corner from the dock as shown in the picture.