Tower of Terror - Elevator Indicator

prusaprinters

<p>This are the models for the hand of the Tower of Terror Elevator Indicator. I did not make the <a href="https://www.thingiverse.com/thing:2020139">original models</a>, they were made by <a href="https://www.thingiverse.com/hrjunior/designs">HRJunior</a> on Thingiverse. I have made some changes, such as…</p><ul><li>Reduced geometry complexity</li><li>Cut some sections to make them easier to print</li><li>Cut some sections to fit smaller beds</li></ul><p>Printing this took roughly an entire spool.</p><p>You can adjust the infill on most parts to suite you and your print times. I wouldn't go lower than 10% on the back plates as you'll run the risk of holes if you do.</p>