Tower + Base Coupler for MKII Wind Turbine

thingiverse

I designed this connector to pair the base with a 1-1/2" PVC pipe for my MKII 5W Wind Turbine tower. The hole running through the middle saves material, reduces print time, and allows you to route wires out the bottom of the tower. Find the turbine here: http://www.thingiverse.com/thing:2060281 If you want to use it for something else, this connector has a 2.01" outside diameter on the large end, a 1.5" outside diameter on the small end, and stands 3-7/8" tall. UPDATE: I printed one out and it required some sanding to fit into the base and tower perfectly. I uploaded a revised file with a slightly smaller diameter that should need less post-print work to fit (depending on your printer and settings). Print Settings Printer: Anet A8 Rafts: None Supports: None Resolution: 0.2 Infill: 20% Notes: 20% infill should make this strong enough. I haven't printed it yet, but measurements are close enough. Maybe some slight sanding is needed.