Towelhanger for glue on the wall

thingiverse

I tried out some designs from www.thingiverse.com but most of them were poorly designed and the one I liked had a flaw, causing the hock to break off when the foot stayed on the wall. So, I got fed up looking for a finished design and created my own. This can hold three towels at once, one on each knob and one in the crack between the two knobs. Make sure you glue it securely to the wall and do a stress test before gluing it. I used 45% infill because my towels are large. Depending on how you orient the model, you might not need any supports. The original Solid Edge PAR file is attached, as well as the STL file. Update: Both the PAR and STL files were too small, so scaling by 200% will work fine. However, this will increase the crack between the two knobs, so I recommend editing the PAR file to have a spacing of only 1mm, saving it as an STL file, and then scaling it by 200%. This will give you perfect results.