towel rack bracket

prusaprinters

<p>for mounting with tesa adhesive screws 2.5kg (77902-00002-00)</p> <p>there is 8cm between the wall to the center of the rod.</p> <p>I have uploaded two variants, Ø15mm and Ø20mm to deliver a more flush look for the Räcka curtain rod that i intended to use for this project.</p> <p>the print is assymetrical and will need a mirrored partner.</p> <h3>Print Settings</h3> <p><strong>Printer Brand:</strong></p> <p>Creality</p> <p class="detail-setting printer"><strong>Printer: </strong> <div><p>Ender 5</p></div> <p><strong>Rafts:</strong></p> <p>Doesn't Matter</p> <p class="detail-setting supports"><strong>Supports: </strong> <div><p>Yes</p></div> <p><strong>Resolution:</strong></p> <p>0.2mm</p> <p class="detail-setting infill"><strong>Infill: </strong> <div><p>10%</p></div> <p><strong>Filament:</strong> devil design pla natural</p> <p><br/> <p class="detail-setting notes"><strong>Notes: </strong></p> </p><div><p>i printed with support in the indent for the anchor to ensure that the overhang would come out with minimal post processing.</p></div> Post-Printing ============= <p>Due to printing with support on the upper overhang i went through the cavity with a stubby knife to ensure good fitment between the anchor and the part.</p> <h3>How I Designed This</h3> <p>I wanted to print a strong bracket with more flair than just a wedge against the wall. To add strength in the direction of the adhesive anchor to the rod and back down to the bottom of the print i added in triangular support structures, this was also done to minimize the amount of material used on the print.</p> </p></p></p> Category: Bathroom