Towbar step

prusaprinters

Every time I put the kayak on the roof of the car and step on the towbar, it gets a little bit tricky. But now with this step it will be easy. And I can sit on it if needed.PrintingAll parts are printable without supports and recommended material is PETG, ASA or PC with 4 perimeters and 30% or higher density of infill.Pre-assemblyScrew two screws of size M8 with internal hew head and length 20 mm into the LOCK partAssembly1st stepYou need a European style hitch with a 50mm ball.2nd stepYou put on the tightening nut. Pay attention to its orientation, the nut belongs with the narrower side up.3rd stepPlace the main part on the ball.4th stepInsert the LOCK part into the BODY section from the top.5th stepTurn the LOCK part downwards so that the two parts of the thread are next to each other.6th stepTighten the nut.