Touch Mi - I3 Mega clip support

thingiverse

This support can be clipped directly to the hot end without any adhesive, screws or other fasteners.\r\nThe sensor can be plugged into the Sensor pin on the motherboard at PIN 11.\r\n\r\nThe "Touch Mi" sensor is available at the hotends.fr store.\r\n(I am not affiliated with this company.)\r\n\r\nMarlin 1.1.8 firmware can be used to enable automatic bed leveling.\r\n\r\nTo set up, you will need a 4cm x 4cm offset between the nozzle and sensor.\r\nThis setting prevents full bed probing but allows for proper linear leveling.\r\n\r\nYou will require one M3 screw and nut, approximately 16mm in length.\r\n\r\nFuture updates plan to utilize a magnet to automatically activate the sensor.\r\nFor now, the sensor must be released manually and placed safely after each G29 command.