Touch Desk Lamp

thingiverse

This is a basic desk lamp featuring a single touch switch located at the top. The LED strip used is WS2812, the touch switch is TTP223, and the controller is Atmega8. The lamp measures 17 cm in height and has a diameter of 10 cm. As seen in the photos, assembly is remarkably straightforward. Pre-built firmware for an Atmega8 along with source code can be downloaded from my GitHub Project Page (https://github.com/ReneLu/desk_lamp). The project was created using AtmelStudio 7. In addition to the assembly instructions, a schematic of the electronic components is also included in the photo set. Please note that I assume no responsibility for any injuries or damages sustained while assembling the circuit or utilizing the lamp. If you're unsure about how to assemble the circuit, consider having someone with knowledge do it instead. To build this desk lamp, you'll need: - WS2812 LED Strip - TTP223 Sensor - Atmega8 or another MCU that meets the following requirements: at least 2534 bytes of flash and 158 bytes of RAM - A Micro USB Port or an alternative means to supply your circuit with 5 volts.