Totoro with rgb led belly and remote

thingiverse

Based on Totoro Glowing Lamp by Forehead Reduced depth added simple support for led module so it sits a bit tilted in the belly These led lamps are found on ebay etc as Colorful Submersible 10 LED RGB Party Vase Light Remote Control Lamp or Submersible 10 LED RGB Light Party Vase Underwater Last 2 pictures are typically seen in the listings They cost about 3 USD from china and consist of a clear case remote control and a pcb with 10 RGB leds and holder for 3AAA battery's There is a very nice fade option through the remote that works just right The pcb can be removed by removing 3 little screws once opening the case The belly cover was printed in clear ABS and the remote works fine You simply put the pcb with battery's in the belly and close it There is some play but the pcb does not rattle around to much Print Settings Printer Malyan M150 Rafts No Supports No Resolution 0.3 Infill 15% cubic in Cura Notes Body printed in PLA some extruding issue hence why it's a bit rough belly cover was printed in ABS but I'm assuming it will also work fine with clear PLA Example body was printed at 0.3 finish would be far better in 0.2