Torch Quick Clip - 22mm

thingiverse

This is just the beginning of my line of creations designed for use with my Quick Clip system.... The Quick Clip system relies on quick release clips and attachments used by UK Emergency Services. This Torch Quick Clip securely holds your torch to any of my Quick Clip holders, available right here on Thingiverse: Quick Clip Belt Holder, Quick Clip Car Vent Holder - https://www.thingiverse.com/thing:3374629, and the full Quick Clip collection - https://www.thingiverse.com/mikeevans991/collections/quick-clip. The clip's design allows it to hold your torch securely through a 360-degree turn, releasing only when your torch is turned upside down. To construct this, you'll need: 2x M3 6mm Screws and 2x M3 Nuts. If you'd like the same torch shown here, check out https://amzn.to/2FOVAst. My filament cost for this Quick Clip is under £0.05, printing in less than 20 minutes! Please leave a comment and share your creations if you use it :).