Top Mounted Receiver Housing for GepRC PX3

thingiverse

I needed to squeeze a split camera into my stack on the GepRC PX3, but with the receiver inside the frame, there wasn't enough room. So I came up with a housing that sits atop the top plate with the receiver inside. This design was centered around the Fli14+ receiver, which has a relatively large enclosure (28mm x 17.2mm x 6.3mm). However, it should be able to accommodate different receivers as well. The housing is still a work in progress - I plan to trim some bulk off the edges for a sleeker look. For now, though, it's functional and gets the job done. Keep in mind that this design doesn't raise the receiver off the carbon top plate, so you'll need to use shrink wrap to secure your receiver in place.