Toothpick Dispenser

thingiverse

This is my initial endeavor at making a printable object, replicating the "sanitary toothpick dispensers" typically found in restaurants. As I don't own a 3DP yet and it's my first attempt, I'm uncertain about its printability. Your feedback on design or file improvements for better printing would be appreciated. Some of my concerns are: the 90mm high walls at 1mm thickness might not meet stability guidelines; the unsupported sloped ramp inside may cause printing issues; and fitting of pieces after printing is uncertain. Ideally, there should be a stop limiting the cylinder's rotation to around 100 degrees to avoid toothpick wastage. Please feel free to suggest changes or improvements. Thanks to mikeq for pointing out my difference function error. If you print this, kindly review the OpenScad code first to ensure its successful printing. Assembly is straightforward: insert the cylinder into the cabinet and attach knobs through the corresponding holes using glue if needed. To use, rotate the cylinder so the slot aligns with the opening, then back again for a toothpick.