TOOTHPASTE HOLDER SPRING & EXTRUDER

thingiverse

That's My Idea of Toothpaste Holder Extruder. If You Want One You Need to Print the Five Pieces. You Can Fix It to the Wall by Screw and Nylon Bushing or Using Extra Strong VHB Ribbon from 3M or Another You Prefer. Assembly: First Step - To Assemble It, You Must Fasten the "Toothpaste_Holder_square_Grooved" Piece in the Rectangular Recess on the Left Side of the Extruder Through a Super Glue. Second Step - Place the M-Shaped Spring into the Rectangular Recess Inside the Right-Hand Cylinder of the Extruder. Third Step - Insert from Right to Left the Shaft Through the Central Bore of the Spring and the Extruder. Fourth Step - Using Super Glue Attach the "Toothpaste_Holder_Lock" at the Free End of the Left Side Axle. Be Careful Not to Stick the Lock in the Slotted Rectangle. To Prevent This from Happening, Press the Handle at the Right End of the Shaft to Move the Lock Away from the Other Part Until the Glue Dries. To Use: Put the Bottom of Toothpaste Tube Through Lower Opening in the Extruder Half Cane and Place the Tip in the Notch There Are in the Shaft. Then Lightly Press the Right Side Handle to Release the Rotation of the Shaft and Rotate in the Direction That You Are at a Small Angle to Ensure That the Paste Tube Will Not Fall Off, Then Release the Handle to Lock the Turn Again. The Procedure of Pressing and Rotating the Handle Must Be Repeated to Remove Paste from the Tube. Always Rotate the Handle Toward You When You Want to Pick Up Toothpaste. This Prevents the Mouth of Toothpaste Tube from Rotating Towards the Wall and This Can Make the Removal of Toothpaste More Difficult. To Remove the Empty Paste Tube, Press and Rotate the Handle in the Opposite Direction Until the Empty Tube is Completely Unwound and Can Be Removed from the Extruder. Enjoy This Project and Do a Good Job!