Toothed plate for Infento Multijoint

thingiverse

I created this element as an alternative over using the combination of 1 l-joint+2 swivel plates, BECAUSE Infento’s straight positioning blocks have too much clearance. This backlash can be quite annoying when try to build something stiff in both directions e.g. a steering bar. You can combine it with both types of the red knurled discs, and it does not even need to be printed with a high resolution to create an absolutely stiff and strong connection w/o slug. The height of the whole stack comes down to the common 40mm grid. The multijoint can be adjusted within a range of 90° (if that’s not enough just turn the whole element by 90° on the profile’s end). The required center bolt is M8x50 or 55. I printed with 0.6mm nozzle and 0.3mm layer height, no support. The print time was ~60mins.