Toothbrush holder

thingiverse

Some toothbrush holders come with a large design and some have a slim one. This holder is designed to fit all types of toothbrushes and toothpaste tubes perfectly. It can either be printed in several parts that can be glued together or as just two parts that press-fit perfectly (when printing ABS). The base goes deeper into the tube, lifting it up a few millimeters from the surface it's on. This allows water to run out easily and get wiped away regularly. Make sure to pay close attention to how the bottom plate is placed on the print bed since it has a beveled edge on one side. This lets water flow down to the middle and into the hole. If water collects, it can start to stink after a while. Print Settings Printer: Prusa Supports: No Resolution: 0.2 Infill: 30 Notes: You can print this super fine or up to 0.3 resolution, depending on how fast you want it done and if you'll be post-processing it. Infill doesn't matter; use your own judgment. Post-Printing Acetone might work well Spray painting could be an option Sanding is also possible All of these are optional