ToolKitRC M6 Replacement Foot

prusaprinters

<p>If you have the ToolKitRC M6, you know how fragile the tiny little feet on the bottom can be. I broke one of those feet after a few months of use and then there wasn't any good way to make sure the fan on the bottom had airflow during charging. I proceeded to draw up this simple little foot to fix it and replaced both the originals. The new version doesn't fold up like the original, but it is much sturdier.</p><p>I recommend printing it on its side and then sand down the top/bottom as necessary to get a good press fit. The model was designed 6.1-mm thick, which is pretty close to the required thickness. SolidWorks 2020 (I think) file included.</p>