Tooling cylinder

grabcad

Mass = 3079.89 grams1. Make a side profile to later rotate. Make the top half the cylinder by making a center line which sits on a 134 mm line. Starting from the side make a 19mm line 25mm above the line and then another line coming from that 15mm high and another line horizontal 28.5mm long. Make a small line at an angle going down at 45degrees and connect a line from that line to the centerline and add R2 fillets wo the angles form the first two lines lastly mirror all that. Then revolve all that for a cylinder. Make a sketch on the smaller circle face which make a horizontal and vertical central lines. Make a slot in the top half from the center 24 long by R3 and cut off the right half. Plus section out the top right quarter to cut through as well as the slot half. Mass = 2687.46 grams2. Complete the rectangle in the back with central lines and make 2 circles coming from that one R35 and one R30. Make a line from the Centre of that drawn rectangle at 10degrees and at the bottom 25 degrees. Cut the access off. Add 12 circle to the front big circle face by making one 7.5D circle on a 64D circle at 15degrees from the center and use circle pattern for the rest and cut though all.Mass = 2636.78 grams3. Make a sketch on the from smaller circle, start by offsetting its contours by 4mm and cutting the access off and getting a half circle with a small nudge> extrude cut that by 10 and filet the inside line by 1mm.