Tooling Cylinder

grabcad

(Mass and other info at bottom)Tooling Cylinder 1I started by drawing the top half of the front profile and revolved it. I then drew the 2, 12 mm lines with the arc with a radius of 3 connecting them. I then used the extruded cut tool to cut through the body. Tooling Cylinder 2I drew a 19x15 square and in the furthest corner from the body i drew a circle with a radius of 35 and another one with a radius of 30. I then used construction lines and dimensioned the angles. Once I got the shape I needed, I used the extrude cut tool to cut through the body. I then used construction lines to figure out where the circles would go. Once I dimensioned the angles I drew a 64mm circle and put a 7.5mm circle on the intersecting lines. I then used circular sketch pattern and used the extruded cut tool.Tooling Cylinder 3I drew 3 lines, each 4 mm away from the circular shape. I then used an arc to connect the lines and cut the contour by 10 and used a fillet. Mass = 2636.17 gramsVolume = 333692.91 cubic millimetersSurface area = 62106.63 square millimeters